Toyota Yaris: Wiper / Washer / Front Wiper Rubber
Components
COMPONENTS
ILLUSTRATION
*1 | FRONT WIPER BLADE | *2 | FRONT WIPER RUBBER |
*3 | FRONT WIPER RUBBER BACKING PLATE | - | - |
Removal
REMOVAL
CAUTION / NOTICE / HINT
Click here
Installation
INSTALLATION
CAUTION / NOTICE / HINT
Click here
ComponentsCOMPONENTS ILLUSTRATION
*1 WINDSHIELD WIPER MOTOR AND LINK *2 COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY *3 FRONT WIPER ARM HEAD CAP *4 FRONT WIPER ARM AND BLADE ASSEMBLY LH *5 FRONT WIPER ARM AND BLADE ASSEMBLY RH *6 FRONT FENDER TO COWL SIDE SEAL RH *7 FRONT FENDER TO COWL SIDE SEAL LH - -
N*m (kgf*cm, ft...
Other information:
DESCRIPTION If air does not flow from the front registers after the blower switch on the air conditioning control assembly is operated, the following factors may be the cause. Symptom Factor Blower motor does not operate at all
(Air does not blow from registers)
Harness or connector
Air conditioning amplifier assembly malfunction
Blower motor with fan sub-assembly malfunction
Warm-up control
Engine coolant temperature sensor malfunction
PROCEDURE 1...
INSPECTION PROCEDURE 1. INSPECT WINDSHIELD WIPER SWITCH ASSEMBLY (a) Check the resistance. (1) Measure the resistance according to the value(s) in the table below. Standard Resistance: Front Wiper Switch Tester Connection Condition Specified Condition z5-14 (MIST) -z5-5 (E) MIST position Below 1 Ω z5-14 (MIST) -z5-5 (E) Except MIST position 10 kΩ or higher z5-10 (W_OFF) - z5-5 (E) OFF position Below 1 Ω z5-10 (W_OFF) - z5-5 (E) Except OFF position 10 kΩ or higher z5-13 (+S) - z5-5 (E) AUTO position Below 1 Ω z5-13 (+S) - z5-5 (E) Except AUTO position 10 kΩ or higher z5-11 (+1) - z5-5 (E) LO position Below 1 Ω z5-11 (+1) - z5-5 (E) Except LO position 10 kΩ or higher z5-12 (+2) - z5-5 (E) HI position Below 1 Ω z5-12 (+2) - z5-5 (E) Except HI position 10 kΩ or higher Front Washer Switch Tester Connection Condition Specified Condition z5-15 (WF) - z5-5 (E) ON position Below 1 Ω z5-15 (WF) - z5-5 (E) OFF position 10 kΩ or higher Auto Sensitivity Adjustment Switch Tester Connection Condition Specified Condition z5-4 (VR) - z5-5 (E) P1 position 1102 to 1218 Ω z5-4 (VR) - z5-5 (E) P2 position 570 to 630 Ω z5-4 (VR) - z5-5 (E) P3 position 256...
Categories
If a key is left in the vehicle, the functions of the key left in the vehicle
are temporarily suspended to prevent theft of the vehicle.
To restore the functions, press the unlock button on the functions-suspended
key in the vehicle.
read more