Toyota Yaris: SRS Air Bags / Front Passenger Occupant Classification System
First, please read “Supplemental Restraint System (SRS) Precautions”
carefully.
The following illustration is an example of an accident that may not be
detected as a roll-over accident. Therefore, the front seat belt pretensioners
and curtain air bags may not deploy...
Your vehicle is equipped with a front passenger occupant classification
sensor as a part of the supplemental restraint system. This sensor is equipped
in the front passenger’s seat cushion...
Other information:
ComponentsCOMPONENTS ILLUSTRATION
*1 DECK TRIM SIDE PANEL ASSEMBLY RH *2 4WD ECU ASSEMBLY
N*m (kgf*cm, ft.*lbf): Specified torque - - RemovalREMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the 4WD ECU removal/installation are shown below...
INSTALLATION PROCEDURE 1. INSTALL STUD BOLT (a) Using an E8 "TORX" socket wrench, install the stud bolt to the turbocharger sub-assembly. Torque: 10 N·m {102 kgf·cm, 7 ft·lbf} 2. INSTALL TURBO WATER PIPE GASKET (a) Install the new turbo water pipe gasket to the turbocharger sub-assembly...
Categories
The front and side supplemental restraint systems (SRS) include different
types of air bags. Please verify the different types of air bags
which are equipped on your vehicle by locating the “SRS AIRBAG”
location indicators. These indicators are visible in the area where the
air bags are installed.
The air bags are installed in the following locations:
The steering wheel hub (driver air bag)
The front passenger dashboard (front passenger air bag)
The outboard sides of the front seatbacks (side air bags)
The front and rear window pillars, and the roof edge along both
sides (curtain air bags)
read more