Toyota Yaris: Front Camera System / Fail-safe Chart

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual / Engine & Hybrid System / Cruise Control / Front Camera System / Fail-safe Chart

FAIL-SAFE CHART

FAIL-SAFE FUNCTION

(a) If a malfunction is detected in the front camera system, the systems that use the front camera system perform the fail-safe function.

Freeze Frame Data

FREEZE FRAME DATA DESCRIPTION (a) When a front camera system DTC is stored, the forward recognition camera stores the current vehicle (ECU or sensor) state as Freeze Frame Data...

Data List / Active Test

DATA LIST / ACTIVE TEST HINT: Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts...

Other information:

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Stop and Start System does not Operate (Battery Condition)

DESCRIPTION When the stop and start system does not operate, check whether the operation is prohibited because the auxiliary battery conditions are not met. Data List items Hood Courtesy Switch Auxiliary Battery Current Auxiliary Battery Fluid Temperature (Start) Auxiliary Battery Fluid Temperature Idling Stop Rate Total Idling Stop Rate Integrated Current Status of Auxiliary Battery Charge Control Minimum Voltage (Cranking) Minimum Voltage (Starter Solenoid Engagement) State of BBC Stop&Start Operating Permission (Power Management) Stop&Start Operating Permission (Minimum Voltage (Starter Solenoid Engagement)) Stop&Start Operating Permission (Minimum Voltage (Cranking)) Stop&Start Operating Permission (Integrated Current) Stop&Start Operating Prohibition (Jump Start) Stop&Start Operating Prohibition (Manual Start for the First Time) Auxiliary Battery Type Ambient Temperature Alternator Status NOTICE: If the Data List item Stop&Start Operating Permission (Power Management) is "NG" even after correcting a certain problem using the diagnostic troubleshooting procedures, the problem may be due to the auxiliary battery charge amount being temporarily low or the auxiliary battery may be deteriorated...

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Terminals Of Ecu

TERMINALS OF ECU CHECK MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY (a) Disconnect the L13 multiplex network master switch assembly connector. (b) Measure the voltage and resistance according to the value(s) in the table below. HINT: Measure the values on the wire harness side with the connector disconnected...