Toyota Yaris: Wiper And Washer System / Dtc Check / Clear

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual / Vehicle Exterior / Wiper / Washer / Wiper And Washer System / Dtc Check / Clear

DTC CHECK / CLEAR

CHECK FOR DTC

(a) Check for DTCs.

Body Electrical > Main Body > Trouble Codes

CLEAR DTC

(a) Clear the DTCs.

Body Electrical > Main Body > Clear DTCs

Terminals Of Ecu

TERMINALS OF ECU CHECK MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) AND POWER DISTRIBUTION BOX ASSEMBLY *1 Power Distribution Box Assembly *2 Main Body ECU (Multiplex Network Body ECU) (a) Remove the main body ECU (multiplex network body ECU) from the power distribution box assembly...

Data List / Active Test

DATA LIST / ACTIVE TEST DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not...

Other information:

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Camshaft Position Sensor "B" Bank 1 Circuit Short to Ground (P036511,P036515)

DESCRIPTION The camshaft position sensor (for exhaust camshaft) (EV1 signal) consists of a magnet and MRE (Magneto Resistance Element). The exhaust camshaft has a timing rotor for the camshaft position sensor. When the exhaust camshaft rotates, changes occur in the air gaps between the timing rotor and MRE, which affects the magnetic field...

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Inspection

INSPECTION PROCEDURE 1. INSPECT AUTO HIGH BEAM SWITCH (a) Check the resistance. (1) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition H47-5 (+B) - H47-2 (E) Auto high beam switch off 10 kΩ or higher H47-5 (+B) - H47-2 (E) Auto high beam switch on Below 1 Ω If the result is not as specified, replace the auto high beam switch...