Toyota Yaris: Cxpi Communication System / Data List / Active Test

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual / Power Source & Network / Networking / Cxpi Communication System / Data List / Active Test

DATA LIST / ACTIVE TEST

READ DATA LIST

NOTICE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

HINT:

Using the GTS to read the Data List allows values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

(a) Enter the following menus: Body Electrical / Main Body / Data List.

(b) According to the display on the GTS, read the Data List.

Body Electrical > Main Body > Data List

Tester Display	Measurement Item	Range	Normal Condition	Diagnostic Note
Communication Power Integration No.1	Connection status between semiconductor power integration ECU and main body ECU (multiplex network body ECU)	OK or STOP	OK: Connection STOP: No connection	When there is a malfunction, a DTC is stored.
Communication Power Integration No.2	Connection status between No. 2 semiconductor power integration ECU and main body ECU (multiplex network body ECU)	OK or STOP	OK: Connection STOP: No connection	This item is displayed but not used
Communication Power Integration No.3	Connection status between No. 3 semiconductor power integration ECU and main body ECU (multiplex network body ECU)	OK or STOP	OK: Connection STOP: No connection	This item is displayed but not used
Communication Power Distribution Box	Connection status between power distribution box assembly and main body ECU (multiplex network body ECU)	OK or STOP	OK: Connection STOP: No connection	When there is a malfunction, a DTC is stored.

Fail-safe Chart

F..

Diagnostic Trouble Code Chart

D..

Other information:

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Test Mode Procedure

TEST MODE PROCEDURE ACTIVATE DEALER MODE (SIGNAL CHECK) HINT: Signals related to the vehicle stability control system can be inspected by performing a Dealer Mode (Signal Check) inspection. During the inspection, the display of items determined normal by the skid control ECU (brake actuator assembly) changes from incomplete to complete...

Toyota Yaris XP210 (2020-2026) Owner's Manual: Driving Tips

Passing For extra power when passing another vehicle or climbing steep grades, depress the accelerator fully. The transaxle will shift to a lower gear, depending on vehicle speed. Some models: The accelerator pedal may initially feel heavy as it is being depressed, then feel lighter as it is depressed further...