Toyota Yaris: Manifold Absolute Pressure Sensor / Components
COMPONENTS
ILLUSTRATION
| *1 | NO. 2 TURBO PRESSURE SENSOR | *2 | NO. 1 TURBO PRESSURE SENSOR |
| *3 | ENGINE WIRE | - | - |
| N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT NO. 1 TURBO PRESSURE SENSOR (a) Check the terminal voltage. (1) Disconnect the No. 1 turbo pressure sensor connector...
Other information:
REMOVAL PROCEDURE 1. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Click here
2. REMOVE STOP LIGHT SWITCH ASSEMBLY (a) Disconnect the connector.
(b) Remove the stop light switch assembly as shown in the illustration.
Remove in this Direction 3...
DESCRIPTION If the ECM cannot recognize the millimeter wave radar sensor assembly. DTC U040181 is stored. DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from U040181 Invalid Data Received from ECM/PCM "A" Invalid Serial Data Received Approximately 17 seconds or more after the ignition switch is turned to ON, the ECM cannot recognize the millimeter wave radar sensor assembly for approximately 5 seconds or more...
Categories
WARNING
Never allow a person to ride in the luggage compartment/trunk
Allowing a person to ride in the luggage compartment/trunk is
dangerous.
The person in the luggage compartment/trunk could be seriously injured or
killed during sudden braking or a collision.
Do not drive with the liftgate/trunk lid open
read more