Toyota Yaris: Manual Transaxle System / Check For Intermittent Problems
CHECK FOR INTERMITTENT PROBLEMS
CLEAR DTCS
Click here
PERFORM SIMULATION TEST
Click here
CHECK AND WIGGLE HARNESSES, CONNECTORS AND TERMINALS
Click here
CAUTION / NOTICE / HINT HINT:
The ECM of this system is connected to the CAN communication system. Therefore, before starting troubleshooting, be sure to check that there are no malfunctions in the CAN communication system...
ROAD TEST ROAD TEST (a) Check for DTCs. Click here
Powertrain > Engine > Trouble Codes HINT: When DTCs are output, perform troubleshooting for each DTC...
Other information:
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the rear drive shaft assembly removal/installation are shown below...
DESCRIPTION Refer to DTC C050C1F. Click here
DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from C050C23 Left Rear Wheel Speed Sensor Signal Stuck Low Any of the following is detected:
When the +BS terminal voltage is 17...
Categories
The fuel gauge shows approximately how much fuel is remaining in
the tank when the ignition is switched ON. We recommend keeping
the tank over 1/4 full.

Full
1/4 Full
Empty
read more