Toyota Yaris: Switches and Controls / Windshield Wipers and Washer

Toyota Yaris XP210 (2020-2026) Owner's Manual / When Driving / Switches and Controls / Windshield Wipers and Washer

The ignition must be switched ON to use the wipers.

Because heavy ice and snow can jam the wiper blades, the wiper motor is protected from motor breakdown, overheating and possible fire by a circuit breaker. This mechanism will automatically stop operation of the blades, but only for about 5 minutes.

If this happens, turn off the wiper switch and park off the right-of-way, and remove the snow and ice.

After 5 minutes, turn on the switch and the blades should operate normally. If they do not resume functioning, consult your Toyota dealer as soon as possible. Drive to the side of the road and park off the right-of-way. Wait until the weather clears before trying to drive with the wipers inoperative.

WARNING

Use only windshield washer fluid or plain water in the reservoir

Using radiator antifreeze as washer fluid is dangerous. If sprayed on the windshield, it will dirty the windshield, affect your visibility, and could result in an accident.

Only use windshield washer fluid mixed with anti-freeze protection in freezing weather conditions

Using windshield washer fluid without anti-freeze protection in freezing weather conditions is dangerous as it could freeze on the windshield and block your vision which could cause an accident. In addition, make sure the windshield is sufficiently warmed using the defroster before spraying the washer fluid.

Three-Flash Turn Signal

After releasing the turn signal lever, the turn signal indicator flashes 3 times. The operation can be cancelled by moving the lever in the direction opposite to which it was operated...

Windshield Wipers

With intermittent wiper Turn the wipers on by pressing the lever up or down. Variable-speed intermittent wipers Set the lever to the intermittent position and choose the interval timing by rotating the ring...

Other information:

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Relay

On-vehicle InspectionON-VEHICLE INSPECTION PROCEDURE 1. INSPECT WINDSHIELD WIPER RELAY (a) Check the operation of the windshield wiper relay. (1) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition 3 - 5 Auxiliary battery voltage not applied between terminals 1 and 2 10 kΩ or higher Auxiliary battery voltage applied between terminals 1 and 2 Below 1 Ω If the result is not as specified, replace the windshield wiper relay...

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Front Right Microphone Circuit Component Internal Failure (B1AA696,B1AA71C)

DESCRIPTION These DTCs are stored when a malfunction occurs in the active noise control microphone RH system. DTC No. Detection Item DTC Detection Condition Trouble Area B1AA696 Front Right Microphone Circuit Component Internal Failure Stereo component equalizer assembly detects malfunction in active noise control microphone RH for 4 seconds or more continuously when engine speed is 1200 rpm or more* Harness or connector Active noise control microphone RH Stereo component equalizer assembly B1AA71C Front Right Microphone Circuit Circuit Voltage Out of Range Stereo component equalizer assembly detects active noise control microphone RH connection malfunction for 4 seconds or more continuously* Harness or connector Active noise control microphone RH Stereo component equalizer assembly HINT: *: Malfunction monitoring is not performed under the following conditions, in order to prevent erroneous detection...