Toyota Yaris: Manual Type / Windshield Defrosting and Defogging
- Set the mode selector dial to the
position.
- Set the temperature control dial to the desired position.
- Set the fan control dial to the desired speed.
- If dehumidified heating is desired, turn on the air conditioner.
- For maximum defrosting, turn on the air conditioner, set the temperature
control dial to the extreme hot position, and turn the fan control dial
fully
clockwise.
- If warm air is desired at the floor, set the mode selector dial to the
position.
- In the
or
position, the air conditioner is automatically turned on
and the outside air position is automatically selected to defrost the
windshield. In the
or
position, the outside air position cannot be
changed to the recirculated air position.
WARNING
Do not defog the windshield using the
position with the
temperature control set to the cold position
Using the
position with the temperature control set to the cold position is
dangerous as it will cause the outside of the windshield to fog up.
Your vision will be hampered, which could lead to a serious accident. Set
the temperature control to the hot or warm position when using the
position.
Set the mode selector dial to the
position.
Set the air intake selector to the outside air position.
Set the temperature control dial to the desired position...
Operate the air conditioner in cool or cold weather to help defog the
windshield and side windows.
Set the mode selector dial to the desired position...
Other information:
DESCRIPTION Detection Item Symptom Trouble Area Engine Stop and Start ECU Communication Stop Mode Communication stop for "Stop and Go/Start" is indicated on the "Communication Bus Check" screen of the GTS. Click here
Engine stop and start ECU branch line or connector
Power source circuit of engine stop and start ECU
Engine stop and start ECU ground circuit
Engine stop and start ECU
WIRING DIAGRAM
CAUTION / NOTICE / HINT CAUTION: When performing the confirmation driving pattern, obey all speed limits and traffic laws...
DESCRIPTION The forward recognition camera controls the flow of current to the forward recognition with heater hood sub-assembly. If the forward recognition camera detects a malfunction in the forward recognition with heater hood sub-assembly circuit, it will store this DTC...
Categories
No special break-in is necessary, but a few precautions in the first 600
miles (1,000 km) may add to the performance, economy, and life of
the vehicle.
Do not race the engine.
Do not maintain one constant speed, either slow or fast, for a long
period of time.
Do not drive constantly at full-throttle or high engine rpm for
extended periods of time.
Avoid unnecessary hard stops.
Avoid full-throttle starts.
read more