Toyota Yaris: Owner Maintenance / Window Washer Fluid
Inspecting Washer Fluid Level
Inspect fluid level in the washer
fluid reservoir; add fluid if necessary.

Use plain water if washer fluid is unavailable.
But use only washer fluid in cold weather to prevent it from freezing.
- State or local regulations may restrict the use of volatile organic
compounds
(VOCs), which are commonly used as anti-freeze agents in washer fluid. A
washer fluid with limited VOC content should be used only if it provides
adequate freeze resistance for all regions and climates in which the vehicle
will
be operated.
- Front and rear washer fluid is supplied from the same reservoir.
WARNING
Use only windshield washer fluid or plain water in the reservoir
Using radiator antifreeze as washer fluid is dangerous. If sprayed on
the
windshield, it will dirty the windshield, affect your visibility, and could
result
in an accident.
Using Washer Fluid Without Anti-freeze Protection in Cold Weather
Operating your vehicle in temperatures below 40 °F (4 °C) using washer
fluid without anti-freeze protection is dangerous as it could cause impaired
windshield vision and result in an accident. In cold weather, always use
washer fluid with anti-freeze protection.
The brakes and clutch draw fluid from the same reservoir.
Inspect the fluid level in the reservoir regularly. It should be kept
between the MAX and MIN lines...
All moving points of the body, such as door and hood hinges
and locks, should be lubricated each time the engine oil is
changed. Use a nonfreezing lubricant on locks during cold
weather...
Other information:
DESCRIPTION The main body ECU (multiplex network body ECU) detects whether either the rear doors are open or closed based on the courtesy light switch condition and then sends the rear door status signal to the combination meter assembly. The power distribution box assembly detects whether either the rear seat belts are fastened or unfastened based on the rear seat belt buckle switch condition and then sends the rear seat belt buckle switch status signal to the combination meter assembly...
On-vehicle InspectionON-VEHICLE INSPECTION PROCEDURE 1. INSPECT WINDSHIELD WIPER RELAY (a) Check the operation of the windshield wiper relay. (1) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition 3 - 5 Auxiliary battery voltage not applied between terminals 1 and 2 10 kΩ or higher Auxiliary battery voltage applied between terminals 1 and 2 Below 1 Ω If the result is not as specified, replace the windshield wiper relay...
Categories
WARNING
When removing the fuel-filler cap, loosen the cap slightly and wait
for
any hissing to stop, then remove it
Fuel spray is dangerous. Fuel can burn skin and eyes and cause illness
if
ingested. Fuel spray is released when there is pressure in the fuel tank and
the fuel-filler cap is removed too quickly.
read more