Toyota Yaris: Owner Maintenance / Brake/Clutch Fluid

Toyota Yaris XP210 (2020-2026) Owner's Manual / Maintenance and Care / Owner Maintenance / Brake/Clutch Fluid

The brakes and clutch draw fluid from the same reservoir.

Inspect the fluid level in the reservoir regularly. It should be kept between the MAX and MIN lines.

The level normally drops with accumulated distance, a condition associated with wear of brake and clutch linings. If it is excessively low, have the brake/clutch system inspected by your Toyota dealer.

Toyota Yaris. Brake/Clutch Fluid

WARNING

If the brake/clutch fluid level is low, have the brakes inspected

A low brake/clutch fluid level is dangerous.

A low level could indicate brake lining wear or a brake system leak which could cause the brakes to fail and lead to an accident.

Engine Coolant

Inspecting Coolant Level Inspect the antifreeze protection and coolant level in the coolant reservoir at least once a year—at the beginning of the winter season—and before traveling where temperatures may drop below freezing...

Window Washer Fluid

Inspecting Washer Fluid Level Inspect fluid level in the washer fluid reservoir; add fluid if necessary. Use plain water if washer fluid is unavailable...

Other information:

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Driver Frontal Stage 1 Deployment Control Circuit Short to Battery (B000112)

DESCRIPTION DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate Test Mode / Check Mode B000112 Driver Frontal Stage 1 Deployment Control Circuit Short to Battery The airbag sensor assembly detects a short to B+ in the driver seat airbag squib circuit for 0...

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Input/Turbine Speed Sensor "A" Circuit Short to Battery (P071512,P071514)

DESCRIPTION The transmission revolution sensor is mounted on the transaxle. The ECM calculates the transaxle input shaft speed using the sensor. When the input shaft rotates, the sensor generates a pulse signal and sends the signal to the ECM. The ECM calculates the input shaft speed based on the signal...