Toyota Yaris: Customer Information  and Reporting Safety Defects / Warranty

Reporting Safety Defects (Canada)

Canadian customers who wish to report a safety-related defect to Transport Canada, Defect Investigations and Recalls, may telephone the toll free hotline 1-800-333-0510, or contact Transport Canada by mail at: Transport Canada, ASFAD, Place de Ville Tower C, 330 Sparks Street, Ottawa ON K1A 0N5...

Warranties for Your Toyota

New Vehicle Limited Warranty Powertrain Limited Warranty Safety Restraint System Limited Warranty Anti-perforation Limited Warranty Federal Emission Control Warranty/California Emission Control Warranty Emission Defect Warranty Emission Performance Warranty Emission Control Warranty Replacement Parts and Accessories Limited Warranty Tire Warranty Warranty information varies depending on the country...

Other information:

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Intake Air Temperature Sensor 1 Bank 1 Circuit Short to Battery or Open (P011015)

DESCRIPTION Refer to DTC P011011. Click here HINT: When DTC P011015 is stored, the ECM enters fail-safe mode. During fail-safe mode, the intake air temperature is estimated to be 20°C (68°F) by the ECM. Fail-safe mode continues until a pass condition is detected, and the ignition switch is then turned off...

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: On-vehicle Inspection

ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT STOP LIGHT SWITCH ASSEMBLY (a) Disconnect the stop light switch assembly connector. (b) Measure the voltage and resistance on the wire harness side connector according to the value(s) in the table below. Standard Voltage: Tester Connection Condition Specified Condition A63-7 (B) - A63-2 (GND) Always 11 to 14 V A63-6 (B) - A63-2 (GND) Ignition switch on (IG) 11 to 14 V Standard Resistance: Tester Connection Condition Specified Condition A63-2 (GND) - Body ground Always Below 1 Ω If the result is not as specified, repair or replace the wire harness or connector...