Toyota Yaris: Warranty / Outside the United States/Canada
Government regulations in the United States/Canada require that
automobiles meet specific emission regulations and safety standards.
Therefore, vehicles built for use in the United States/Canada may differ from
those sold in other countries.
The differences may make it difficult or even impossible for your vehicle to
receive satisfactory servicing in other countries. We strongly
recommend that you NOT take your Toyota outside the United States/Canada.
United States
However, in the event that you are moving to Canada permanently,
Toyota vehicles built for use in the United States could be eligible for
exportation to Canada with specific vehicle modifications to comply
with the Canadian Motor Vehicle Safety Standards (CMVSS).
Canada
However, in the event that you are moving to the United States permanently,
Toyota vehicles built for use in Canada could be eligible for
exportation to the United States with specific vehicle modifications to
comply with the United States Federal Motor Vehicle Safety Standards
(FMVSS).
You may have the following problems if you do take your vehicle outside of
the United States/Canada:
- Recommended fuel may be unavailable. Any kind of leaded fuel or
low-octane fuel will affect vehicle performance and damage the
emission controls and engine.
- Proper repair facilities, tools, testing equipment, and replacement
parts may not be available.
Please refer to your Manufacturer’s “Owner’s Warranty Information
Booklet” or “Owner’s Manual Supplement/Scheduled Maintenance
Guide” for more information.
The above is applicable for a permanent import/export situation and not
related to travelers on vacation.
New Vehicle Limited Warranty
Powertrain Limited Warranty
Safety Restraint System Limited Warranty
Anti-perforation Limited Warranty
Federal Emission Control Warranty/California Emission Control
Warranty
Emission Defect Warranty
Emission Performance Warranty
Emission Control Warranty
Replacement Parts and Accessories Limited Warranty
Tire Warranty
Warranty information varies depending on the country...
Non-genuine parts and accessories for Toyota vehicles can be found
in stores.
These may fit your vehicle, but they are not approved by Toyota for
use with Toyota vehicles...
Other information:
ELECTRONIC CIRCUIT INSPECTION PROCEDURE BASIC INSPECTION (a) WHEN MEASURING RESISTANCE OF ELECTRONIC PARTS (1) Unless otherwise stated, all resistance measurements are standard values measured at an ambient temperature of 20°C (68°F). Resistance measurements may be inaccurate if measured at high temperatures, i...
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during engine unit removal/installation are shown below. Necessary Procedure After Parts Removed/Installed/Replaced Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Engine assembly
Cylinder head sub-assembly
Camshaft (for intake or exhaust camshaft)
Camshaft timing gear assembly
Camshaft timing exhaust gear assembly
Fuel injector assembly
Fuel pump (for low pressure side)
Fuel pump assembly (for high pressure side)
Fuel pressure sensor (for low pressure side)
Fuel pressure sensor (for high pressure side)
Spark plug
Ignition coil assembly
Air intake system parts
Exhaust system parts
Turbocharger sub-assembly
Inspection after repair
Poor idle, etc...