Toyota Yaris: Window Defogger System / System Description

Toyota Yaris XP210 (2020-2025) Reapir and Service Manual / Vehicle Exterior / Window / Glass / Window Defogger System / System Description

SYSTEM DESCRIPTION

GENERAL

(a) The rear window defogger wire (back door glass) is attached to the inside of the rear window and defogs the window surface quickly when the rear window defogger switch is pressed. The indicator light on the switch illuminates while the system is operating. This system automatically turns off after approximately 15 minutes.

NOTICE:

If the auxiliary battery voltage becomes low, auxiliary battery load control will operate in order to ensure sufficient power is supplied to the power steering system. In this case, the window defogger system may not operate.

HINT:

The window defogger system is linked with the mirror heater function.

FUNCTION OF MAIN COMPONENT

Component

Outline

Rear Window Defogger Switch (Air Conditioning Control Assembly)

Sends signals to the air conditioning amplifier assembly to operate the window defogger system.

Air Conditioning Amplifier Assembly

Sends a window defogger system activation request signal to the power distribution box assembly.

Power Distribution Box Assembly

Receives a window defogger system activation request signal from the air conditioning amplifier assembly and supplies power to the rear window defogger wire (back door glass).

Rear Window Defogger Wire (Back Door Glass)

Receives power from the power distribution box assembly and heats the rear window using the rear window defogger wire (back door glass).

    System Diagram

    S..

    How To Proceed With Troubleshooting

    CAUTION / NOTICE / HINT HINT: Use the following procedure to troubleshoot the window defogger system. *: Use the GTS. PROCEDURE 1. VEHICLE BROUGHT TO WORKSHOP NEXT 2...

    Other information:

    Toyota Yaris XP210 (2020-2025) Reapir and Service Manual: Problem Symptoms Table


    PROBLEM SYMPTOMS TABLE If there are no DTCs output and the problem still occurs, check the suspected areas for each problem symptom in the order given in the following table and proceed to the relevant troubleshooting page. NOTICE: When replacing the skid control ECU (brake actuator assembly), sensors, etc...

    Toyota Yaris XP210 (2020-2025) Reapir and Service Manual: Removal


    REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the knock sensor removal/installation are shown below. Necessary Procedure After Parts Removed/Installed/Replaced Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link Replacement of throttle body with motor assembly Cleaning the deposits from the throttle body with motor assembly Air leaks from intake system Replacement of knock control sensor Inspection after repair Poor idle, etc...

    Categories

    Turning the Engine Off

    Stop the vehicle completely. Manual transaxle: Shift into neutral and set the parking brake.

    Automatic transaxle: Shift the selector lever to the P position and set the parking brake.

    Press the push button start to turn off the engine. The ignition position is off.

    read more

     
    Copyright © 2025 www.toyaris4.com