Toyota Yaris: Emergency Starting / Push-Starting
Do not push-start your Toyota.
You cannot start a vehicle with an automatic transaxle by pushing it.
WARNING
Never tow a vehicle to start it
Towing a vehicle to start it is dangerous. The vehicle being towed
could
surge forward when its engine starts, causing the 2 vehicles to collide. The
occupants could be injured.
NOTICE
Do not push-start a vehicle that has a manual transaxle. It can damage
the
emission control system.
If the engine fails to start, it may be flooded (excessive fuel in
the engine).
Follow this procedure:
If the engine does not start within 5 seconds on the first try, wait 10
seconds and try again...
If the high engine coolant temperature warning light turns on,
the vehicle loses power, or you hear a loud knocking or pinging
noise, the engine is probably too hot...
Other information:
INSTALLATION PROCEDURE 1. INSTALL COOLER CONDENSER ASSEMBLY (a) Engage the guide to install the cooler condenser assembly. NOTICE: Do not damage the cooler condenser assembly or radiator assembly when installing the cooler condenser assembly. HINT: If a new cooler condenser assembly is installed, add compressor oil to the cooler condenser assembly as follows...
DESCRIPTION This DTC is stored when there is a malfunction in the certification ECU (smart key ECU assembly) auxiliary battery power supply circuit or ground circuit. DTC No. Detection Item DTC Detection Condition Trouble Area Note B228B00 Battery Circuit or Ground Circuit Energization Malfunction A malfunction is detected in the certification ECU (smart key ECU assembly) auxiliary battery power supply circuit or ground circuit...
Categories

Smart key
Auxiliary key
Key code number plate
To use the auxiliary key, press the knob and pull out the auxiliary key
from the smart key.

read more