Toyota Yaris: Stop And Start System / Problem Symptoms Table

Toyota Yaris XP210 (2020-2025) Reapir and Service Manual / Engine & Hybrid System / Stop And Start / Stop And Start System / Problem Symptoms Table

PROBLEM SYMPTOMS TABLE

Stop and Start System

Symptom	Suspected Area	Link
Stop and start system does not operate	Refer to "Stop and Start System does not Operate"
Stop and start system does not operate	Refer to "Stop and Start System does not Operate (Battery Condition)"
Restarting after a short period of time from an idling stop	Refer to "Restarting after a Short Period of Time from an Idling Stop"
After engine stops due to stop and start system, engine does not restart	Refer to "After Engine Stops due to Stop and Start System, Engine does not Restart"
Failure to restart from IG-ON engine stall	Refer to "Failure to Restart from IG-ON Engine Stall"
Stop and start cancel indicator does not operate	Combination meter assembly
	Indicator circuit (CAN communication system)
	Engine stop and start ECU
Stop and start indicator does not operate	Combination meter assembly
	Indicator circuit (CAN communication system)
	Engine stop and start ECU
Stop and start control cannot be canceled	ECAN terminal voltage
Stop and start control cannot be canceled	Stop and start cancel switch circuit
Multi-information display screen does not change after pressing steering pad switch assembly.	Stop and start priority control system
Multi-information display screen changes without pressing steering pad switch assembly.	Stop and start priority control system
Multi-information display screen does not change but control mode changes.	Stop and start priority control system
Multi-information display screen changes but control mode does not change.	Stop and start priority control system
Control mode returns to default mode after turning ignition switch to ON	Stop and start priority control system

Registration

REGISTRATION PROCEDURE 1. ECU EXCHANGE NOTICE: When replacing the engine stop and start ECU, make sure to download the number of starter operations (step 1)...

Terminals Of Ecu

TERMINALS OF ECU ENGINE STOP AND START ECU (a) Disconnect the engine stop and start ECU connectors. (b) Measure the resistance and voltage according to the value(s) in the table below...

Other information:

Toyota Yaris XP210 (2020-2025) Reapir and Service Manual: Lack of Power

DESCRIPTION Problem Symptom Suspected Area Trouble Area Engine speed fluctuation due to abnormal combustion Idle speed too low or high Strong engine vibration due to above symptoms Ignition malfunction Deviation in air fuel ratio (Excessive or insufficient intake air volume or fuel supply) Insufficient compression Changes in load from another system Ignition system Spark plug Ignition coil assembly Fuel system Direct fuel injector assembly Port fuel injector assembly Fuel pump assembly (for high pressure side) Fuel pump (for low pressure side) Fuel pump control circuit Fuel suction plate sub-assembly Fuel main valve assembly Fuel line Purge VSV system Fuel quality (existence of foreign matter, degradation) Intake and exhaust systems Mass air flow meter sub-assembly Intake system (Air leaks or deposit accumulation) Throttle body with motor assembly Air fuel ratio sensor (sensor 1) Air fuel ratio sensor (sensor 2) Cam timing oil control solenoid assembly Variable Valve Timing system (VVT system) Other control systems ECM Wire harness or connector Knock control sensor Engine coolant temperature sensor Engine Water control valve Engine assembly High load from another system Air conditioning system Power steering system Electrical load signal system SYMPTOM AND CAUSE OF SYSTEM MALFUNCTION HINT: The following are descriptions of the characteristics of each system malfunction...

Toyota Yaris XP210 (2020-2025) Owner's Manual: How to Arm the System

Close the windows securely. Switch the ignition OFF. Make sure the hood, the doors, and the liftgate/trunk lid are closed. Press the lock button on the smart key or lock the driver’s door from the outside with the auxiliary key.The hazard warning lights will flash once...