Toyota Yaris: Differential Mount Cushion / Installation

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual / Drivetrain / Axle And Differential / Differential Mount Cushion / Installation

INSTALLATION

PROCEDURE

1. INSTALL REAR NO. 1 DIFFERENTIAL MOUNT CUSHION

(a) Using SST, install a new rear No. 1 differential mount cushion.

SST: 09316-20011

SST: 09570-24011

*1	Rear Suspension Member Sub-assembly	-	-
*a	0° +/- 3°	*b	15.0 to 16.0 mm (0.591 to 0.630 in.)
*c	Turn	*d	Hold
	Turning Direction		Front of Vehicle
	SST Bolt Position	-	-

NOTICE:

Make sure that the rear No. 1 differential mount cushion is aligned within 3° from the center.
Install the rear No. 1 differential mount cushion so that the protrusion is positioned as shown in the illustration.
Be sure to use the correct combination of SST.
Before using SST, apply grease to SST bolt.
Temporarily install the rear No. 1 differential mount cushion to the rear suspension member sub-assembly in order to prevent it from tilting, and then install SST.
Make sure that SST contacts the entire circumference of the rear No. 1 differential mount cushion.
Do not tilt the bolts of SST.

2. INSTALL REAR DIFFERENTIAL CARRIER ASSEMBLY

Click here

Removal

REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the rear No...

Differential Oil

ComponentsCOMPONENTS ILLUSTRATION *1 REAR DIFFERENTIAL DRAIN PLUG *2 REAR DIFFERENTIAL FILLER PLUG *3 GASKET - - Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft...

Other information:

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Installation

INSTALLATION PROCEDURE 1. INSTALL AUTOMATIC LIGHT CONTROL SENSOR (a) Engage the claws to install the automatic light control sensor. 2. INSTALL INSTRUMENT MAIN PANEL Click here 3. INSTALL FRONT PILLAR GARNISH LH Click here 4. INSTALL FRONT PILLAR GARNISH RH HINT: Use the same procedure as for the LH side...

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Starter Relay Circuit Short to Battery (P061512)

MONITOR DESCRIPTION While the engine is cranked, current flows from terminal STA2 of the engine stop and start ECU to terminal STA of the ECM (STA signal). If the ECM detects the starter control (STA) signal while the vehicle is being driven, it determines that there is a malfunction in the STA circuit...