Toyota Yaris: Maintenance / Front Disc Brake Pad

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual / General / Maintenance / Front Disc Brake Pad

Installation

INSTALLATION CAUTION / NOTICE / HINT NOTICE: Because the left and right front flexible hoses are not interchangeable, verify the part number when installing the front flexible hoses...

Components

C..

Other information:

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Fail-safe Chart


FAIL-SAFE CHART If any of the following DTCs are stored, the engine stop and start ECU enters fail-safe mode to preserve vehicle operability. DTC Component Fail-safe Operation Fail-safe Deactivation Condition P033562 Open in engine speed signal circuit Stop and start control is prohibited Engine is automatically restarted if a DTC is stored while the engine is stopped by stop and start control All of the following conditions are met for 10 seconds: Normal communication with ECM Engine speed 500 rpm or higher Engine speed (communication signal) 500 rpm or higher Difference between engine speed from pulse signal and engine speed from communication signal is less than 100 rpm P055500 P05552A Vacuum sensor assembly Brake booster assembly Vacuum hose (brake booster hose) Stop and start control is prohibited Engine is automatically restarted if a DTC is stored while the engine is stopped by stop and start control One of the following conditions is met: Vacuum changes while the brake pedal is depressed Vacuum changes a specified number of times while the vehicle is being driven faster than a certain vehicle speed P055511 P055515 Vacuum sensor assembly circuit Stop and start control is prohibited Engine is automatically restarted if a DTC is stored while the engine is stopped by stop and start control Sensor output is within standard range P060629 Engine stop and start ECU Stop and start control is prohibited Engine is automatically restarted if a DTC is stored while the engine is stopped by stop and start control Pass condition detected and ignition switch turned to ON P060B1C P060B49 P060B71 Analog to digital converter (Engine stop and start ECU) Stop and start control is prohibited Engine is automatically restarted if a DTC is stored while the engine is stopped by stop and start control Pass condition detected and ignition switch turned to ON P061519 ST NO...

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Installation


INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The following procedure is for the LH side. If the rear speed sensor rotor needs to be replaced, replace the rear axle hub and bearing assembly. PROCEDURE 1...

Categories

Fuel Gauge

The fuel gauge shows approximately how much fuel is remaining in the tank when the ignition is switched ON. We recommend keeping the tank over 1/4 full.

Toyota Yaris. Fuel Gauge

Full 1/4 Full Empty

read more

 
Copyright © 2026 www.toyaris4.com