Toyota Yaris: Manual Transaxle System / Fail-safe Chart

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual / Drivetrain / Ea67f (manual Transmission / Transaxle) / Manual Transaxle System / Fail-safe Chart

FAIL-SAFE CHART

If any of the following DTCs are stored, the ECM enters fail-safe mode.

DTC Code	Fail-Safe Operation	Fail-Safe Deactivation Condition
P071011	iMT system control stopped	Ignition switch off
P071015
P071512
P071514
P080512
P080514

Data List / Active Test

DATA LIST / ACTIVE TEST DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not...

Diagnostic Trouble Code Chart

D..

Other information:

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Software Incompatibility with Body Control Module Invalid/Incompatible Software Component (U032257)

DESCRIPTION The millimeter wave radar sensor assembly receives vehicle specification information from the main body ECU (multiplex network body ECU) and ECM via the CAN communication line. If the vehicle specification information stored in the millimeter wave radar sensor assembly does not match the vehicle specification information sent from the main body ECU (multiplex network body ECU) and ECM, the millimeter wave radar sensor assembly stores DTC U032257...

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: On-vehicle Inspection

ON-VEHICLE INSPECTION PROCEDURE 1. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY Click here 2. DISCONNECT UNION TO CONNECTOR TUBE HOSE Click here 3. OPERATION CHECK (a) Connect the hose of the vacuum gauge to the vacuum pump assembly. *a Vacuum Gauge *b Plug (b) Start the engine and warm it up for more than 2 minutes...