Toyota Yaris: Differential Mount Cushion / Components

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual / Drivetrain / Axle And Differential / Differential Mount Cushion / Components

COMPONENTS

ILLUSTRATION

*1	REAR NO. 1 DIFFERENTIAL MOUNT CUSHION	-	-
●	Non-reusable part	-	-

REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the rear No...

Other information:

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Installation

INSTALLATION PROCEDURE 1. INSTALL FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY (a) Install a new gasket to the fuel tank assembly. (b) Connect the fuel return vent tube sub-assembly to the fuel suction tube with pump and gauge assembly. Click here *1 Fuel Return Vent Tube Sub-assembly Front of the Vehicle Make sure to correctly assemble the fuel return vent tube sub-assembly as shown in the illustration...

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: On-vehicle Inspection

ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT NO. 1 TURBO PRESSURE SENSOR (a) Check the terminal voltage. (1) Disconnect the No. 1 turbo pressure sensor connector. (2) Turn the ignition switch to ON. (3) Measure the voltage according to the value(s) in the table below...

Categories

Break-In Period

No special break-in is necessary, but a few precautions in the first 600 miles (1,000 km) may add to the performance, economy, and life of the vehicle.

Do not race the engine. Do not maintain one constant speed, either slow or fast, for a long period of time. Do not drive constantly at full-throttle or high engine rpm for extended periods of time. Avoid unnecessary hard stops. Avoid full-throttle starts.