Toyota Yaris: Center Airbag Sensor Assembly / Components
COMPONENTS
ILLUSTRATION
| *1 | FRONT FLOOR CARPET ASSEMBLY | *2 | AIRBAG SENSOR ASSEMBLY |
| Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) | - | - |
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the airbag sensor assembly removal/installation are shown below...
Other information:
INSTALLATION PROCEDURE 1. INSTALL RADIATOR DRAIN COCK PLUG (a) Install the O-ring to the radiator drain cock plug. NOTICE: Replace the O-ring if it is damaged. (b) Install the radiator drain cock plug. 2. INSTALL LOWER RADIATOR SUPPORT (a) Install the 2 lower radiator supports to the radiator assembly...
DISASSEMBLY CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. REMOVE REAR TURN SIGNAL LIGHT LED (a) Remove the rear turn signal light LED as shown in the illustration...
Categories
WARNING
Never allow a person to ride in the luggage compartment/trunk
Allowing a person to ride in the luggage compartment/trunk is
dangerous.
The person in the luggage compartment/trunk could be seriously injured or
killed during sudden braking or a collision.
Do not drive with the liftgate/trunk lid open
read more