Toyota Yaris: Wiper Switch / Components
COMPONENTS
ILLUSTRATION
| *1 | LOWER STEERING COLUMN COVER | *2 | UPPER STEERING COLUMN COVER |
| *3 | WINDSHIELD WIPER SWITCH ASSEMBLY | - | - |
REMOVAL PROCEDURE 1. REMOVE LOWER STEERING COLUMN COVER NOTICE: Removing the lower steering column cover in the incorrect order will cause the parts to break...
Other information:
REPLACEMENT CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during diaphragm oil seal replacement are shown below. Necessary Procedure After Parts Removed/Installed/Replaced Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link Gas leaks from exhaust system Inspection after repair
Poor idle, etc...
REASSEMBLY PROCEDURE 1. INSTALL COOLER DRYER (a) Using pliers, install a new cooler dryer to the modulator.
*a Modulator (b) Sufficiently apply compressor oil to the 3 O-rings and fitting surfaces of a new cap. Compressor Oil: ND-OIL 8 or equivalent NOTICE: Keep the O-rings and O-ring fitting surfaces free from dirt or foreign matter...
Categories
The front and side supplemental restraint systems (SRS) include different
types of air bags. Please verify the different types of air bags
which are equipped on your vehicle by locating the “SRS AIRBAG”
location indicators. These indicators are visible in the area where the
air bags are installed.
The air bags are installed in the following locations:
The steering wheel hub (driver air bag)
The front passenger dashboard (front passenger air bag)
The outboard sides of the front seatbacks (side air bags)
The front and rear window pillars, and the roof edge along both
sides (curtain air bags)
read more