Toyota Yaris: Front Door Opening Trim Weatherstrip / Components
COMPONENTS
ILLUSTRATION
| *1 | FRONT DOOR SCUFF PLATE | *2 | COWL SIDE TRIM BOARD |
| *3 | ROOF SIDE RAIL WEATHERSTRIP | *4 | FRONT ROOF SIDE RAIL WEATHERSTRIP RETAINER |
| *5 | FRONT DOOR OPENING TRIM WEATHERSTRIP | - | - |
REMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the LH side and RH side.
The following procedure is for the LH side.
PROCEDURE 1...
Other information:
ComponentsCOMPONENTS ILLUSTRATION
*1 FRONT DRIVE SHAFT OIL SEAL LH - - ● Non-reusable part
MP grease ReplacementREPLACEMENT CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during the front drive shaft oil seal LH removal/installation are shown below...
REMOVAL PROCEDURE 1. SEPARATE ENGINE WIRE (a) Remove the bolt and engine wire.
2. REMOVE IGNITION COIL ASSEMBLY (a) Disconnect the ignition coil assembly connector.
(b) Remove the bolt and ignition coil assembly. 3. REMOVE CAMSHAFT POSITION SENSOR (for Intake Side) (a) Disconnect the camshaft position sensor connector...
Categories
Stop the vehicle completely.
Manual transaxle:
Shift into neutral and set the parking brake.
Automatic transaxle:
Shift the selector lever to the P position and set the parking brake.
Press the push button start to turn off the engine. The ignition position is
off.
read more