Toyota Yaris: Engine Oil / Vehicle Engine Control Unit Reset Procedure
After replacing the engine oil, have a repair shop such as your Toyota
dealer perform the initialization (engine oil data resetting) of the
recorded value. If the value recorded by the computer is not initialized,
the wrench indicator light may not turn off or it may turn on earlier than
normal.
- This procedure is intended for vehicles with the engine oil flexible
maintenance setting selected.
- The initialization (engine oil data resetting) of the recorded value can
be performed using the following procedure:
- Switch the ignition OFF.
- Switch the ignition ON with the selector pressed and continue pressing
the
selector for about 5 seconds until the
master warning light
flashes.
- After the master warning light
flashes for several seconds,
the initialization is completed.

Use SAE 0W-20 engine oil.
Toyota Genuine Motor Oil is used in your Toyota vehicle. Toyota Genuine Motor
Oil 0W-20 is required to achieve optimum fuel economy...
Be sure the vehicle is on a level surface.
Warm up the engine to normal operating temperature.
Turn it off and wait at least 5 minutes for the oil to return to the oil
pan...
Other information:
TERMINALS OF ECU METER MIRROR SUB-ASSEMBLY
(a) Measure the voltage and resistance according to the value(s) in the table below. Terminal No. (Symbol) Terminal Description Condition Specified Condition H61-1 (IG) - Body ground Power source for engine stop and start ECU assembly Ignition switch off Below 1 V Ignition switch ON 10...
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. INSTALL REAR DISC BRAKE ANTI SQUEAL SHIM KIT (a) Install the 2 rear disc brake anti-squeal shims to each rear disc brake pad...
Categories

Smart key
Auxiliary key
Key code number plate
To use the auxiliary key, press the knob and pull out the auxiliary key
from the smart key.

read more