Toyota Yaris: Clutch System / Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
Clutch System| Symptom | Suspected Area | Link |
|---|---|---|
| Clutch grabs/chatters | Engine mounting (Loose) | - |
| Clutch disc assembly (Excessive runout) |
| |
| Clutch disc assembly (Oily) |
| |
| Clutch disc assembly (Worn out) |
| |
| Clutch disc torsion spring (Damaged) |
| |
| Clutch disc assembly (Glazed) |
| |
| Diaphragm spring (Tip out of alignment) |
| |
| Clutch pedal is hard to depress | Clutch pedal (Damaged) |
|
| Clutch fluid (Dirty) |
| |
| Clutch master cylinder assembly (Damaged) |
| |
| Clutch release cylinder with bearing assembly (Damaged) |
| |
| Clutch cover assembly (Damaged) |
| |
| Clutch pedal spongy | Clutch line (Air in line) |
|
| Clutch master cylinder assembly (Damaged) |
| |
| Clutch release cylinder with bearing assembly (Damaged) |
| |
| Clutch noisy | Clutch release cylinder with bearing assembly (Worn, dirty or damaged) |
|
| Clutch disc torsion spring (Damaged) |
| |
| Clutch slips | Clutch disc assembly (Oily) |
|
| Clutch disc assembly (Worn out) |
| |
| Diaphragm spring (Damaged) |
| |
| Pressure plate (Distorted) |
| |
| Flywheel sub-assembly (Distorted) |
| |
| Clutch does not disengage | Clutch line (Air in line) |
|
| Clutch master cylinder assembly (Damaged) |
| |
| Clutch release cylinder with bearing assembly (Damaged) |
| |
| Clutch disc assembly (Out of line) |
| |
| Clutch disc assembly (Excessive runout) |
| |
| Clutch disc assembly (Lining broken) |
| |
| Clutch disc assembly (Dirty or burned) |
| |
| Clutch disc assembly (Oily) |
| |
| Clutch disc assembly (Lack of spline grease) |
|
Bleeding
BLEEDING CAUTION / NOTICE / HINT NOTICE: Wash off clutch fluid immediately if it comes in contact with any painted surface. HINT:
If any work is performed on the clutch system or if air in the clutch lines is suspected, bleed air from the clutch hydraulic system...
Other information:
Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Reassembly
REASSEMBLY PROCEDURE 1. INSTALL NO. 2 ANTENNA CORD SUB-ASSEMBLY Click here 2. INSTALL NO. 1 ROOF WIRE (a) Apply butyl tape onto the roof headlining so that it does not protrude from the markings. *a Butyl Tape - - HINT: Apply the butyl tape securely, making sure that it is not out of position or peeling off...
Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Installation
INSTALLATION PROCEDURE 1. INSTALL REAR BUMPER ASSEMBLY (a) Connect the connector. Install in the Direction (b) Engage the claws to install the rear bumper assembly as shown in the illustration. (c) Engage the claws to install the rear bumper assembly as shown in the illustration...
Categories
- Manuals Home
- Toyota Yaris Owners Manual
- Toyota Yaris Service Manual
- Engine & Hybrid System
- Fuel Gauge
- How to connect USB port/Auxiliary jack
- New on site
- Most important about car
Turning the Engine Off
Stop the vehicle completely. Manual transaxle: Shift into neutral and set the parking brake.Automatic transaxle: Shift the selector lever to the P position and set the parking brake.
Press the push button start to turn off the engine. The ignition position is off.