Toyota Yaris: Clutch / Clutch System
INSTALLATION PROCEDURE 1. INSTALL CLUTCH PEDAL STROKE SENSOR ASSEMBLY (a) When installing a new clutch pedal stroke sensor assembly: NOTICE: Do not break the clutch pedal stroke sensor assembly lever set pin before being instructed to do so...
PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table...
Other information:
DESCRIPTION When the ignition switch is ON, the multiplex network master switch assembly sends remote up and down signals to each door window regulator motor assembly via LIN communication. WIRING DIAGRAM
CAUTION / NOTICE / HINT NOTICE:
The power window control system uses the LIN communication system...
DESCRIPTION Refer to DTC C05121F. Click here
DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from C051223 Right Rear Wheel Speed Sensor Signal Stuck Low Any of the following is detected:
When the +BS terminal voltage is 17...
Categories
The front and side supplemental restraint systems (SRS) include different
types of air bags. Please verify the different types of air bags
which are equipped on your vehicle by locating the “SRS AIRBAG”
location indicators. These indicators are visible in the area where the
air bags are installed.
The air bags are installed in the following locations:
The steering wheel hub (driver air bag)
The front passenger dashboard (front passenger air bag)
The outboard sides of the front seatbacks (side air bags)
The front and rear window pillars, and the roof edge along both
sides (curtain air bags)
read more