Toyota Yaris: Wiper And Washer System / Precaution
PRECAUTION
PRECAUTION FOR WASHER NOZZLE ADJUSTMENT
(a) Do not clean or adjust the washer nozzle with a safety pin, etc. because:
(1) The washer nozzle tip is made of resin and may be damaged.
(2) Adjustment is not necessary for this spray type washer nozzle. If it is necessary to change the nozzle angle, replace the washer nozzle with one that has a different nozzle angle.
Click here
(b) If the washer nozzle is clogged with wax, etc., remove it and clean the nozzle hole with a soft resin brush or other cleaning tool.
PARTS LOCATION ILLUSTRATION
*1 WINDSHIELD WIPER MOTOR ASSEMBLY *2 WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY *3 NO. 1 ENGINE ROOM RELAY BLOCK AND NO...
Other information:
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are replaced during millimeter wave radar sensor assembly removal/installation are shown below. Necessary Procedure After Parts Removed/Installed/Replaced Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link Millimeter wave radar sensor assembly Adjust millimeter wave radar sensor assembly
Dynamic Radar Cruise Control System
Lane Tracing Assist System
Front Radar Sensor System
Pre-collision System
Auto High Beam System
Triangle Target:
Flat Surface Target:
Driving Adjustment:
Update ECU security key Vehicle control history (RoB) are stored
PROCEDURE 1...
DESCRIPTION The ABS solenoid relay is built into the skid control ECU in the brake actuator assembly. The ABS solenoid relay supplies power to the holding solenoid and reduction solenoid. The solenoid relay is turned on 1.5 seconds after the ignition switch is turned to ON, and is turned off if an open or short in the solenoid is detected by self-diagnosis performed when the vehicle is starting off...
Categories
If a key is left in the vehicle, the functions of the key left in the vehicle
are temporarily suspended to prevent theft of the vehicle.
To restore the functions, press the unlock button on the functions-suspended
key in the vehicle.
read more