Toyota Yaris: Cylinder Head / Precaution

HINT:

• Any digits beyond the 0.01 mm (1/1000 in.) place for standard, minimum and maximum values should be used as a reference only.
• When both standard and maximum or minimum values are listed for an inspection, use the standard value as a reference only and base any judgments on the maximum and minimum values.

Cylinder Head

..

Components

COMPONENTS ILLUSTRATION *1 INTAKE VALVE GUIDE BUSH *2 EXHAUST VALVE GUIDE BUSH *3 SPARK PLUG TUBE *4 RING PIN *5 STUD BOLT *6 VALVE SPRING RETAINER LOCK *7 NO...

Other information:

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: On-vehicle Inspection

ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT AUTOMATIC LIGHT CONTROL SENSOR (a) Check the wire harness. (1) Disconnect the automatic light control sensor. (2) Measure the voltage according to the value(s) in the table below. Standard Voltage: Tester Connection Switch Condition Specified Condition H78-1 (CLTB) - H78-2 (CLTE) Ignition switch on (IG) 11 to 14 V If the specified condition is not met, replace the vehicle wire harness...

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Removal

REMOVAL PROCEDURE 1. REMOVE REAR BUMPER SIDE SEAL LH (a) Apply protective tape around the rear bumper assembly. HINT: Use the same procedure for the RH side and LH side. Protective Tape (b) Remove the 5 clips and nut to remove the rear bumper side seal LH...