Toyota Yaris: If Trouble Arises / Parking in an Emergency
The hazard warning lights should
always be used when you stop on
or near a roadway in an emergency.

The hazard warning lights warn
other drivers that your vehicle is a
traffic hazard and that they must
take extreme caution when near
it.

Depress the hazard warning flasher and all the turn signals will flash.
The hazard warning indicator lights in the combination meter flash
simultaneously.
- The turn signals do not work when the hazard warning lights are on.
- Check local regulations about the use of hazard warning lights while the
vehicle is being towed to verify that it is not in violation of the law.
Other information:
INSTALLATION PROCEDURE 1. INSTALL REAR STABILIZER BAR (a) Install the rear stabilizer bar to the rear suspension member sub-assembly with the 4 bolts. Torque: 78 N·m {795 kgf·cm, 58 ft·lbf} NOTICE:
Ensure that the identification mark faces the right side of the vehicle...
ON-VEHICLE INSPECTION PROCEDURE 1. CONNECT GTS (a) Connect the GTS to the DLC3 with the engine switch off. (b) Start the engine and run it at idle. (c) Turn the GTS on. (d) Enter the following menus: Chassis / Brake/EPB / Active Test. HINT: Refer to the GTS operator's manual for further details...
Categories
Stop the vehicle completely.
Manual transaxle:
Shift into neutral and set the parking brake.
Automatic transaxle:
Shift the selector lever to the P position and set the parking brake.
Press the push button start to turn off the engine. The ignition position is
off.
read more