Toyota Yaris: Operating Tips for Audio System / Operating Tips for OGG
OGG is the audio compression format for Xiph. Org Foundation.
Audio data can be created and stored at a higher compression ratio
than MP3.
This unit plays files with the extension (.ogg) as OGG files.
- OGG files written under specifications other than the indicated
specification may not play normally or files or folder names may not
display correctly.
- The file extension may not be provided depending on the computer
operating system, version, software, or settings. In this case, add
the file extension “.ogg” to the end of the file name, and then write it
to the disc.
NOTICE
Do not use an audio file extension on files other than audio files. In
addition,
do not change the audio file extension. Otherwise, the unit will not recognize
the file correctly resulting in noise or a malfunction.
AAC stands for Advanced Audio Coding, which is standardized voice
compression established by the ISO* 1 working group (MPEG). Audio
data can be created and stored at a higher compression ratio than
MP3...
This unit plays audio files as follows:
MP3/WMA/AAC/OGG* 1 files written under specifications other than
the indicated specification may not play normally or files/folder names
may not display correctly...
Other information:
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT STOP LIGHT SWITCH ASSEMBLY (a) Disconnect the stop light switch assembly connector. (b) Measure the voltage and resistance on the wire harness side connector according to the value(s) in the table below. Standard Voltage: Tester Connection Condition Specified Condition A63-7 (B) - A63-2 (GND) Always 11 to 14 V A63-6 (B) - A63-2 (GND) Ignition switch on (IG) 11 to 14 V Standard Resistance: Tester Connection Condition Specified Condition A63-2 (GND) - Body ground Always Below 1 Ω If the result is not as specified, repair or replace the wire harness or connector...
FAIL-SAFE CHART If any of the following DTCs are stored, the engine stop and start ECU enters fail-safe mode to preserve vehicle operability. DTC Component Fail-safe Operation Fail-safe Deactivation Condition P033562 Open in engine speed signal circuit
Stop and start control is prohibited
Engine is automatically restarted if a DTC is stored while the engine is stopped by stop and start control
All of the following conditions are met for 10 seconds:
Normal communication with ECM
Engine speed 500 rpm or higher
Engine speed (communication signal) 500 rpm or higher
Difference between engine speed from pulse signal and engine speed from communication signal is less than 100 rpm
P055500 P05552A
Vacuum sensor assembly
Brake booster assembly
Vacuum hose (brake booster hose)
Stop and start control is prohibited
Engine is automatically restarted if a DTC is stored while the engine is stopped by stop and start control
One of the following conditions is met:
Vacuum changes while the brake pedal is depressed
Vacuum changes a specified number of times while the vehicle is being driven faster than a certain vehicle speed
P055511 P055515 Vacuum sensor assembly circuit
Stop and start control is prohibited
Engine is automatically restarted if a DTC is stored while the engine is stopped by stop and start control
Sensor output is within standard range P060629 Engine stop and start ECU
Stop and start control is prohibited
Engine is automatically restarted if a DTC is stored while the engine is stopped by stop and start control
Pass condition detected and ignition switch turned to ON P060B1C P060B49 P060B71 Analog to digital converter (Engine stop and start ECU)
Stop and start control is prohibited
Engine is automatically restarted if a DTC is stored while the engine is stopped by stop and start control
Pass condition detected and ignition switch turned to ON P061519 ST NO...
Categories

Smart key
Auxiliary key
Key code number plate
To use the auxiliary key, press the knob and pull out the auxiliary key
from the smart key.

read more