Toyota Yaris: Manual Type / Heating

Toyota Yaris XP210 (2020-2026) Owner's Manual / Interior Features / Climate Control System / Manual Type / Heating

Set the mode selector dial to the position.
Set the air intake selector to the outside air position.
Set the temperature control dial to the hot position.
Set the fan control dial to the desired speed.
If dehumidified heating is desired, turn on the air conditioner.

If the windshield fogs up easily, set the mode selector dial to the position.
If cooler air is desired at face level, set the mode selector dial to the position and adjust the temperature control dial to maintain maximum comfort.
The air to the floor is warmer than air to the face (except when the temperature control dial is set at the extreme hot or cold position).

Control Switches

Temperature control dial This dial controls temperature. Turn it clockwise for hot and counterclockwise for cold. Fan control dial This dial allows variable fan speeds...

Cooling

Set the mode selector dial to the position. Set the temperature control dial to the cold position. Set the fan control dial to the desired speed...

Other information:

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: LO-beam Headlight does not Illuminate

DESCRIPTION The main body ECU (multiplex network body ECU) controls the low beam headlights. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: Before replacing the main body ECU (multiplex network body ECU), refer to Registration. Click here First perform the communication function inspections in How to Proceed with Troubleshooting to confirm that there are no CAN communication malfunctions before troubleshooting this symptom...

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Entry Interior Alarm does not Sound

DESCRIPTION The smart key system (for Entry Function) uses the buzzer in the combination meter assembly (meter ECU) to perform various vehicle interior warnings. When the conditions of each warning are met, the certification ECU (smart key ECU assembly) sends a buzzer activation request signal to the combination meter assembly via CAN communication and the buzzer sounds...