Toyota Yaris: Window Defogger System / Diagnosis System

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual / Vehicle Exterior / Window / Glass / Window Defogger System / Diagnosis System

DIAGNOSIS SYSTEM

CHECK DLC3

(a) Check the DLC3.

Click here

INSPECT AUXILIARY BATTERY VOLTAGE

(a) Measure the auxiliary battery voltage with ignition switch off.

Standard Voltage:

11 to 14 V

If the voltage is below 11 V, recharge or replace the auxiliary battery.

Terminals Of Ecu

TERMINALS OF ECU CHECK MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) AND INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY *1 Power Distribution Box Assembly *2 Main Body ECU (Multiplex Network Body ECU) (a) Remove the main body ECU (multiplex network body ECU) from the power distribution box assembly...

Data List / Active Test

DATA LIST / ACTIVE TEST DATA LIST (a) Perform the Active Test according to the display on the GTS. Body Electrical > Power Distribution Box > Data List Tester Display Measurement Item Range Normal Condition Diagnostic Note Rear Defogger Input Signal Window defogger switch signal input condition ON or OFF ON: Window defogger switch is on OFF: Window defogger switch is off - Rear Defogger Output Signal Window defogger output condition ON or OFF ON: Window defogger operates OFF: Window defogger does not operate - Rear Defogger Output Current Window defogger current Min...

Other information:

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Installation

INSTALLATION PROCEDURE 1. INSTALL NO. 1 COOLER THERMISTOR (a) Install the No. 1 cooler thermistor as shown in the illustration. Installation Position: Part Length A 45 to 55 mm (1.77 to 2.17 in.) B 23 to 27 mm (0.906 to 1.06 in.) C 54...

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Inspection

INSPECTION PROCEDURE 1. INSPECT STARTER ASSEMBLY CAUTION: As a large electric current passes through the cable during this inspection, a thick cable must be used. If not, the cable may become hot and cause injury. NOTICE: Perform each of the following tests within 3 to 5 seconds to prevent the coil from burning out...