Toyota Yaris: Exterior Care / Underbody Maintenance

Toyota Yaris XP210 (2020-2026) Owner's Manual / Maintenance and Care / Appearance Care / Exterior Care / Underbody Maintenance

Road chemicals and salt used for ice and snow removal and solvents used for dust control may collect on the underbody. If not removed, they will speed up rusting and deterioration of such underbody parts as fuel lines, frame, floor pan, and exhaust system, even though these parts may be coated with anti-corrosive material.

Thoroughly flush the underbody and wheel housings with lukewarm or cold water at the end of each winter. Try also to do this every month. Pay special attention to these areas because they easily hide mud and dirt. It will do more harm than good to wet down the road grime without removing it.

The lower edges of doors, rocker panels, and frame members have drain holes that should not be clogged. Water trapped there will cause rusting.

WARNING

Dry off brakes that have become wet by driving slowly, releasing the accelerator pedal and lightly applying the brakes several times until the brake performance returns to normal

Driving with wet brakes is dangerous. Increased stopping distance or the vehicle pulling to one side when braking could result in a serious accident. Light braking will indicate whether the brakes have been affected.

    Bright-Metal Maintenance

    Use tar remover to remove road tar and insects. Never do this with a knife or similar tool. To prevent corrosion on bright-metal surfaces, apply wax or chrome preservative and rub it to a high luster...

    Aluminum Wheel Maintenance (if equipped)

    A protective coating is provided over the aluminum wheels. Special care is needed to protect this coating. NOTICE Do not use any detergent other than mild detergent...

    Other information:

    Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Crankshaft Position - Camshaft Position Correlation Bank 1 Sensor A (P001600,P001700)


    DESCRIPTION In the VVT (Variable Valve Timing) system, the appropriate intake and exhaust valve open and close timing is controlled by the ECM. The ECM performs intake and exhaust valve control by performing the following: 1) controlling the camshaft, cam timing oil control solenoid assembly, camshaft timing gear bolt (camshaft timing oil control valve) and operating the camshaft timing gear; and 2) changing the relative positions of the camshaft and crankshaft...

    Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Starter Relay Signal Compare Failure (P061562)


    DESCRIPTION When the STA signal detected by the ECM and by the engine stop and start ECU do not match, the engine stop and start ECU stores DTC P061562 and blinks the stop and start cancel indicator. DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate Memory Note P061562 Starter Relay Signal Compare Failure Both of the following conditions are met for 2 seconds or more (1 trip detection logic): Normal communication with the ECM...

    Categories

    Turning the Engine Off

    Stop the vehicle completely. Manual transaxle: Shift into neutral and set the parking brake.

    Automatic transaxle: Shift the selector lever to the P position and set the parking brake.

    Press the push button start to turn off the engine. The ignition position is off.

    read more

     
    Copyright © 2026 www.toyaris4.com