Toyota Yaris: Introduction / Terms

Inspection Mode Procedure

INSPECTION MODE PROCEDURE INSPECTION MODE (a) for Gasoline Model, Diesel Model, LPG Model: The following table shows the types of inspection mode that are available, their purpose and the control that occurs in mode...

Abbreviations Used In Manual

ABBREVIATIONS USED IN MANUAL Abbreviation Meaning ABS Anti-Lock Brake System A/C Air Conditioner AC Alternating Current ACC Accessory ACIS Acoustic Control Induction System ACM Active Control Engine Mount ACSD Automatic Cold Start Device ACT Actuator A...

Other information:

Toyota Yaris XP210 (2020-2022) Reapir and Service Manual: Removal

REMOVAL PROCEDURE 1. REMOVE REAR BUMPER SIDE SEAL LH (a) Apply protective tape around the rear bumper assembly. HINT: Use the same procedure for the RH side and LH side. Protective Tape (b) Remove the 5 clips and nut to remove the rear bumper side seal LH...

Toyota Yaris XP210 (2020-2022) Reapir and Service Manual: Relay

On-vehicle InspectionON-VEHICLE INSPECTION PROCEDURE 1. INSPECT HORN RELAY ASSEMBLY (a) Check the resistance. (1) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition 3 - 5 Auxiliary battery voltage not applied between terminals 1 and 2 10 kΩ or higher 3 - 5 Auxiliary battery voltage applied between terminals 1 and 2 Below 1 Ω If the result is not as specified, replace the horn relay assembly...