Toyota Yaris: Before Driving / Steering Wheel

Fuel-Filler Cap

OpenTo remove the fuel-filler cap, turn it counterclockwise. Attach the removed cap to the inner side of the fuel lid. CloseTo close the fuel-filler cap, turn it clockwise until a click is heard...

Steering Wheel Adjustment

To change the angle or length of the steering wheel: Stop the vehicle, and then pull down the lock release lever under the steering column. Tilt the steering wheel and/or adjust the steering column length to the desired positions, then push the lever up to lock the column...

Other information:

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: On-vehicle Inspection

ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT STOP LIGHT SWITCH ASSEMBLY (a) Disconnect the stop light switch assembly connector. (b) Measure the voltage and resistance on the wire harness side connector according to the value(s) in the table below. Standard Voltage: Tester Connection Condition Specified Condition A63-7 (B) - A63-2 (GND) Always 11 to 14 V A63-6 (B) - A63-2 (GND) Ignition switch on (IG) 11 to 14 V Standard Resistance: Tester Connection Condition Specified Condition A63-2 (GND) - Body ground Always Below 1 Ω If the result is not as specified, repair or replace the wire harness or connector...

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Catalyst System Efficiency Below Threshold Bank 1 (P042000)

MONITOR DESCRIPTION The ECM uses air fuel ratio sensors mounted in front of and behind the Three-Way Catalytic Converter (TWC) to monitor its efficiency. The first sensor, the air fuel ratio sensor (sensor 1), sends pre-catalyst information to the ECM...