Toyota Yaris: Exterior Care / Plastic Part Maintenance
- When cleaning the plastic lenses of the lights, do not use gasoline,
kerosene, rectified spirit, paint, thinner, highly acidic detergents, or
strongly alkaline detergents. Otherwise, these chemical agents can
discolor or damage the surfaces resulting in a significant loss in
functionality. If plastic parts become inadvertently exposed to any of
these chemical agents, flush with water immediately.
- If plastic parts such as the bumpers become inadvertently exposed
to chemical agents or fluids such as gasoline, oil, engine coolant, or
battery fluid, it could cause discoloration, staining, or paint peeling.
Wipe off any such chemical agents or fluids using a soft cloth immediately.
- High water temperature and high water pressure car washers are
available depending on the type of high pressure car washer
device. If the car washer nozzle is put too close to the vehicle or
aimed at one area for an extended period of time, it could deform
plastic parts or damage the paint.
- Do not use wax containing compounds (polish). Otherwise, it could
result in paint damage.
- In addition, do not use an electrical or air tool to apply wax.
Otherwise, the frictional heat generated could result in deformation of
plastic parts or paint damage.
A protective coating is provided over the aluminum wheels. Special
care is needed to protect this coating.
NOTICE
Do not use any detergent other than mild detergent...
WARNING
Do not spray water in the cabin
Splashing water on electrical parts such as the audio unit and switches
is
dangerous as it could cause a malfunction or a fire...
Other information:
Be sure the vehicle is on a level surface.
Warm up the engine to normal operating temperature.
Turn it off and wait at least 5 minutes for the oil to return to the oil
pan.
Pull out the dipstick, wipe it clean, and reinsert it fully.
Full
OK
Low
Pull it out again and examine the level...
ON-VEHICLE INSPECTION PROCEDURE 1. FUEL PUMP ASSEMBLY OPERATION (a) Check fuel pressure. (1) Connect the GTS to the DLC3. (2) Turn the ignition switch to ON. (3) Turn the GTS on. (4) Start the engine. (5) Enter the following menus: Powertrain / Engine / Active Test / Control the Target Fuel Pressure Offset...
Categories

Smart key
Auxiliary key
Key code number plate
To use the auxiliary key, press the knob and pull out the auxiliary key
from the smart key.

read more