Toyota Yaris: Starting the Engine / Emergency Operation for Starting the Engine

Toyota Yaris XP210 (2020-2026) Owner's Manual / When Driving / Start/Stop Engine / Starting the Engine / Emergency Operation for Starting the Engine

If the KEY warning light (red) illuminates, or the push button start indicator light (amber) flashes, this could indicate that the engine may not start using the usual starting method. Have your vehicle inspected at your Toyota dealer as soon as possible. If this occurs, the engine can be force-started. Press and hold the push button start until the engine starts. Other procedures necessary for starting the engine such as having the key in the cabin, and depressing the clutch pedal (manual transaxle) or the brake pedal (automatic transaxle) are required.

Engine Start Function When Key Battery is Dead

If the engine cannot be started due to a dead key battery, the engine can be started using the following procedure: Continue to depress the brake pedal firmly until the engine has completely started...

Turning the Engine Off

Stop the vehicle completely. Manual transaxle: Shift into neutral and set the parking brake.Automatic transaxle: Shift the selector lever to the P position and set the parking brake...

Other information:

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Freeze Frame Data

FREEZE FRAME DATA DESCRIPTION The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can be helpful in determining whether the vehicle was moving or stationary, whether the engine was warmed up or not, whether the air fuel ratio was lean or rich, as well as other data recorded at the time of a malfunction...

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Reassembly

REASSEMBLY CAUTION / NOTICE / HINT NOTICE: Do not drop the power steering ECU assembly, strike it with tools or subject it to impacts. If the power steering ECU assembly is subjected to an impact, replace it with a new one. Do not pull the wire harness...