Toyota Yaris: How to Arm the System / To Turn Off an Armed System

Toyota Yaris XP210 (2020-2026) Owner's Manual / Before Driving / Security System / How to Arm the System / To Turn Off an Armed System

An armed system can be turned off using any one of the following methods:

Pressing the unlock button on the smart key.
Starting the engine with the push button start.
With the advanced keyless function:
Pressing a request switch on the doors.

The hazard warning lights will flash twice.

When the doors are unlocked by pressing the unlock button on the smart key while the theft deterrent system is turned off, the hazard warning lights will flash twice to indicate that the system is turned off.

How to Arm the System

Close the windows securely. Switch the ignition OFF. Make sure the hood, the doors, and the liftgate/trunk lid are closed. Press the lock button on the smart key or lock the driver’s door from the outside with the auxiliary key...

To Stop the Alarm

A triggered alarm can be turned off using any one of the following methods: Pressing the unlock button or the trunk button (4-door) on the smart key...

Other information:

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: On-vehicle Inspection

ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT STOP LIGHT SWITCH ASSEMBLY (a) Disconnect the stop light switch assembly connector. (b) Measure the voltage and resistance on the wire harness side connector according to the value(s) in the table below. Standard Voltage: Tester Connection Condition Specified Condition A63-7 (B) - A63-2 (GND) Always 11 to 14 V A63-6 (B) - A63-2 (GND) Ignition switch on (IG) 11 to 14 V Standard Resistance: Tester Connection Condition Specified Condition A63-2 (GND) - Body ground Always Below 1 Ω If the result is not as specified, repair or replace the wire harness or connector...

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Components

COMPONENTS ILLUSTRATION *A w/ Pre-collision System *B w/o Pre-collision System *1 INNER REAR VIEW MIRROR ASSEMBLY *2 INNER REAR VIEW MIRROR STAY HOLDER COVER *3 NO. 1 FORWARD RECOGNITION COVER *4 NO. 2 FORWARD RECOGNITION COVER N*m (kgf*cm, ft...