Toyota Yaris: Cruise Control / To Decrease Cruising Speed

Toyota Yaris XP210 (2020-2026) Owner's Manual / When Driving / Cruise Control / To Decrease Cruising Speed

Press the SET/- switch and hold it. The vehicle will gradually slow. Release the switch at the desired speed.

Press the SET/- switch and release it immediately to adjust the preset speed. Multiple operations will decrease the preset speed according to the number of times it is operated.

Decreasing speed with a single SET/- switch operation
Instrument cluster display for vehicle speed indicated in mph: 1 mph (1.6 km/h)

Instrument cluster display for vehicle speed indicated in km/h: 1 km/h (0.6 mph)

To Increase Cruising Speed

Follow either of these procedures. To increase speed using cruise control switch Press the RES/+ switch and hold it. Your vehicle will accelerate. Release the switch at the desired speed...

To Resume Cruising Speed at More Than 16 mph (25 km/h)

If the cruise control system temporarily canceled (such as applying the brake pedal) and the system is still activated, the most recent set speed will automatically resume when the RES/+ switch is pressed...

Other information:

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Lost Communication with Battery Monitor Module Missing Message (P162B87)

DESCRIPTION The ECM and battery state sensor assembly each detect reception malfunctions. A battery state sensor assembly reception malfunction detected by the battery state sensor assembly is sent to the ECM via LIN communication. If there is a malfunction in either the ECM or battery state sensor assembly, the ECM determines that there is a LIN communication malfunction and outputs a DTC...

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Inspection

INSPECTION PROCEDURE 1. INSPECT HEADLIGHT LEVELING SWITCH (a) Check the voltage. (1) Connect a positive (+) lead from the auxiliary battery to terminal 5 (B) and a negative (-) lead to terminal 2 (E). *a Component without harness connected (Headlight Leveling Switch) (2) Measure the voltage according to the value(s) in the table below...